Canon FY8-13HR-000, Руководство по обслуживанию

Страница: 58 / 105

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2001
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-16
4.3 Copier Interface Board
The copier interface board in the iR-M1 provides the interface between the iR-M1 and the
copier. The copier interface board attaches to motherboard connector J17. The copier inter-
face port on one edge of the board connects to the copier interface cable that plugs into the
copier.
F04-403-01 Copier interface board layout
4.3.1 To Remove the Copier Interface Board
1. Power off and open the iR-M1 as described on page 4-3 and page 4-4. For stability dur-
ing service, remove the front panel as described on page 4-6.
2. Remove the screw on the side of the port bracket that secures the copier interface board
to the port bracket.
3. Remove the copier interface board from motherboard connector J17.
Grasp the board at the sides. Gently pull the board straight up, until it releases from the
connector.
4. Place the copier interface board in an antistatic bag.
4.3.2 To Replace the Copier Interface Board
1. Insert the copier interface board into motherboard connector J17. Make sure that the
copier interface port is in its slot.
2. Replace the screw you removed earlier to secure the copier interface board to the port
bracket.
3. Replace the front panel as described on page 4-7.
4. Reassemble the iR-M1 and verify its functionality as described on page 4-11.
Copier interface port
To connector J17 on
the motherboard