Canon FY8-13HR-000, Руководство по обслуживанию

Страница: 30 / 105

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2001
CHAPTER 3 INSTALLATION
3-4
1.3 Verifying the Connection
After you connect the iR-M1 to the copier, print the Test Page to verify that the connec-
tion between the iR-M1 and the copier is good.
1.3.1 Printing the iR-M1 Test Pages
Before connecting the iR-M1 to the network, print the Test Pages to verify that it is con-
nected properly to the copier. The PS and PCL Test Pages are PostScript files that reside on
the iR-M1 hard disk drive. Print both pages to make sure the connection is operating.
a. To Print the Test Page from the Control Panel
1. Power on the copier and allow it to warm up.
2. Power on the iR-M1 using the power switch on the back panel.
Messages will appear on the Control Panel as the iR-M1 runs through its Start-up diag-
nostics.
3. Before proceeding, make sure that the copier is not in use.
4. At the Idle screen, press the menu button (see “Using the Control Panel” on page 3-9).
The Functions menu displays.
F03-103-01
5. Press the line selection button to the right of Print Pages and then select PS Test Page.
The iR-M1 sends the PS Test Page to the copier and displays the RIP and Print status
screens so you can monitor the job.
6. Press the line selection button to the right of Print Pages again and then select PCL Test
Page.
The iR-M1 sends the PCL Test Page to the copier and displays the RIP and Print status
screens so you can monitor the job.
7. Examine the quality of the Test Pages from the copier.
Suspend Printing
Resume Printing
Reboot Server
Functions
Run Setup
Run Diagnostics
Print Pages
Functions
Select