Canon FAX-L350, Руководство по обслуживанию

Страница: 125 / 213

3-14
FAX-L350 Chapter 3: Maintenance and Service
c) ERROR CODE LIST for FAX-L350
The error codes used for this fax are as follows.
Codes listed as “New” in the list below indicate new error codes, or codes whose measures differ from
those listed in the separate document G3 Facsimile Error Code List (Rev.1) .
For recovery methods for error codes indicated as “New”, see the item d) Recovery methods for codes
indicated as “New” in this chapter, 5.2.2 Error codes.
For items other than “New”, see the separate document G3 Facsimile Error Code List (Rev.1) .
• User error code
No.
Tx or Rx Definition
#001 [ TX ] Paper Jam
#003 [ TX/RX ] Copy Page, Communication Time Over
#005 [ TX/RX ] Initial ID (T1) Time Over
#009 [ RX ] Recording Paper Jam or Out of Paper
#011 [ RX ] Polling Error
#012 [ TX ] Other party Out of Paper
#018 [ TX/RX ] Automatic Dialing Error
#021 [ RX ] DCN during Polling Rx
#022 [ TX ] Call Failure
#037 [ RX ] Image Memory Full
#039 [ TX ] Closed Network Tx Failure
#995 [ TX/RX ] Memory Communication reservation cancellation
• Service error code
No.
Tx or Rx Definition
##100 [ TX ] Excessive Repeat Protocol during Rx
##101 [ TX/RX ] Modem Speed Different from Other Party
##102 [ TX ] Fall Back Failure during Tx
##103 [ RX ] Fail to Detect EOL for 5 Seconds (15 seconds for CBT) during Rx
##104 [ TX ] RTN or PIN Received during Tx
##106 [ RX ] Fail to Receive Protocol for 6 Seconds when Waiting for Protocol dur-
ing Rx
##107 [ RX ] Fall Back Failure on Tx Side during Rx
##109 [ TX ] Receive Signals Other than DIS, DTC, FTT, CFR or CRP after DCS Tx
and Exceed the Number of Protocol re-transmissions during Tx
##111 [ TX/RX ] Memory error
##114 [ RX ] RTN Transmission during Reception
##116 [ TX/RX ] Detect Loop Current Disconnection during Communication
##200 [ RX ] Fail to Detect Picture Rx Carrier for 5 Seconds during Rx
##201 [ TX/RX ] DCN received Other than Normal Binary Protocol
##204 [ TX ] Receive DTC without Tx Data
##220 [ TX/RX ] System Error (main program runaway)
##224 [ TX/RX ] Abnormal Protocol during G3 Communication
##226 [ TX/RX ] Stack Pointer Not within RAM Range
##229 [ RX ] Recording Unit Locked for 1 Minute
##232 [ TX ] ENCODE Control Unit Malfunction
##237 [ RX ] DECODE Control Unit Malfunction
##238 [ RX ] PRINT Control Unit Malfunction
##261 [ TX/RX ] System Error between Modem and SCNT
##280 [ TX ] Excessive Repeat Protocol Command during Tx
##281 [ TX ] Excessive Repeat Protocol Command during Tx
##282 [ TX ] Excessive Repeat Protocol during Tx
##283 [ TX ] Excessive Repeat Protocol during Tx