46
OSD Menu
Item
Setting Options (underline indicates factory default)
HDR/SDR View
In the "Multi View (Dual)" display, the HDR (High Dynamic Range) and SDR (Standard Dynamic
Range) displays can be compared.
On
: The right screen is displayed at SDR luminance.
Off
: Does not compare the HDR and SDR display.
Note
• You cannot set this when the "Picture Mode" or "Peak Luminance Control" for the right screen
is set to "On".
• When the "Contrast" setting for the left screen is specified as "1000" or less, the luminance of
the left and right screens is the same.
Calibration
Performs calibration based on set target values when "User 1-7" is selected for "Picture Mode". Can
be run in the picture mode of the left screen in the "Multi View (Dual)" display.
Luminance
: Sets the target luminance.
48
to
500 (100)
cd/m
2
Color Temperature
: Sets the target color temperature.
D93, D65, D61, D60, D56, D50, DCI-P3
: Select from preset color temperatures.
Custom (xy)
: You can adjust CIE x, y in increments of 0.001.
x: 0.260
to
0.360 (0.313)
/
y: 0.260
to
0.360 (0.329)
Color Gamut
: Sets the color gamut.
SMPTE-C, EBU, ITU-R BT.709, ITU-R BT.2020, Adobe RGB, DCI-P3
Gamma
: Sets the target gamma.
2.2, 2.35, 2.4, 2.6, ITU-R BT.1886
Start
: Performes calibration.
Note
• When "Luminance" is set to high brightness, it may be calibrated beyond the brightness
adjustment range and set lower than the target value, depending on the "Color Temperature"
setting. In that case, set the "Luminance" again.
• Cannot be run in the picture mode of the right screen in the "Multi View (Dual)" display.
Copy
Picture Mode
When "User 1-7" is selected for "Picture Mode", the content of the selected picture mode is copied.
The following modes can be selected:
Picture Mode
:
SMPTE-C, EBU, ITU-R BT.709, ITU-R BT.2020, Adobe RGB, DCI-P3,
User 1-7 (other than the currently set parameter)
Execute
: Performs copy.
Note
• In a picture mode other than "User 1-7", the results of calibration performed at the factory are
copied.
Picture
Mode Name
You can change the name of "User 1-7" within 16 characters including alphabetical characters,
numbers, and symbols.
Anchor Adjustment
Temporarily saves parameters for adjusting "Contrast", "Brightness", "Chroma", and "Sharpness"
and recover the values (anchor point setting).
OK
: Performs anchor point setting.
Cancel
: Returns to the previous screen without setting anchor point.
Reset
Return "Picture Mode" to factory default. Note that in "User 1-7" mode where you are performing
calibration, the setting returns to the value after calibration instead of the factory default.
When selected, the message "Reset Adjustment settings to defaults?" appears.
OK
: Performs reset.
Cancel
: Returns to the previous screen without resetting.
