Canon Color Universal Send Kit-Q1, Руководство по обслуживанию

Страница: 85 / 96

Chapter 4
4-23
4.3.6 FTP Transmission errors
0020-7989
<FTP transmission error message and error code list>
T-4-8
Check address #804 - No match for specified directory name.
- In SMB, a user exists but no write privileges. - Check that the destination directory name is correct.
- Set directory access privileges in the server.
Disk full on the
Server #805 -Document deletion of server
Check address. #806 - Wrongly specified user name.
- Wrongly specified password. (Excl. Windows
NT.) - Change address book user name or password.
No messag #807 No access rights for the specified directory - Check the access rights to the server.
It is generated the
error by the cause of
the servers end. #808 - The server is reset.
There is already
files of this name.
The Over write
prohibition is set. #809 -It sets it to possible Over write on server.
Message Error
code Cause Remedy
No message #022 Address deleted or invalidated during transmission
reservation. - Retransmit deleted address.
- Check that a group address is specified as the transfer destination
and that it contains a valid address.
- Check that a group address is specified as the transfer destination
and whether it contains local print or fax box only.
- Check whether the specified transfer destination address has
been deleted.
Transmission
cancelled #099/ #995 - Transmission cancelled by user. Resend.
HD full #702 Operation stopped because HD full (work area). - Wait a while then retry. Stop broadcast transmission with other
protocols. This sometimes helps to avoid this problem.
HD full #703 Operation stopped because HD full (image area). - Wait a while then retry. Stop broadcast transmission with other
protocols. This sometimes helps to avoid this problem.
Address does not
appear in address
list. #704 - An error occurred when address information was being
obtained from the address list. (Address deleted from list after
scanning, etc. ) - Check address list settings. Or, turn unit OFF/ON.
Address table not
available #706 - Address table being imported/ exported from RUI.
- Address book usage doubled up with other transmission
component (Fax, etc.). - Quit access from RUI.
- Wait a while and then retry
No response #751 - Server has not booted up.
- Network disconnected. (If connection cannot be made with
transmission destination, connection is sometimes cut mid-
way.)
- No Tree name entered.
- Reset caused by internal error. Processing interrupted. - Check transmission destination and network settings.
- Enter Tree name.
- Transmission jobs whose processing has stopped for some reason
or other are forced to quit by assigning an internal error code
(#751). As a result, after rebooting, the job is not run.
TCP/IP error #755 - IP address set to 0.0.0.0. In the following two situations, the
IP address is 0.0.0.0.
1) Address could not be obtained from DHCP, BOOTP,
RARP.
2) Unit launched in IP fixed mode(keys 1+7 to enter
FIXIPmode).
- TCP/IP protocol stack resources insufficient. Even with
internal retry (5 times), transmission failed. - Set the IP address correctly or set DHCP, RARP, BOOTP
environments to operate properly.
- Turn power OFF/ON.
Message Error code Cause Remedy