Canon Color Universal Send Kit-Q1, Руководство по обслуживанию

Страница: 84 / 96

Chapter 4
4-22
T-4-7
Message Error code Cause Remedy
No message #022 Address deleted or invalidated during transmission
reservation. - Retransmit deleted address.
- Check that a group address is specified as the transfer
destination and that it contains a valid address.
- Check that a group address is specified as the transfer
destination and whether it contains local print or fax box
only.
- Check whether the specified transfer destination address
has been deleted.
Transmission
cancelled #099/ #995 - Transmission cancelled by user. Resend.
Address does not
appear in address
list. #704 - An error occurred when address information was
being obtained from the address list. (Address
deleted from list after scanning, etc.) - Check address list settings. Or, turn unit OFF/ON.
HD full #702 Operation stopped because HD full (work area). - Wait a while then retry.
- Stop broadcast transmission with other protocols. This
sometimes helps to avoid this problem.
HD full #703 Operation stopped because HD full (image area). - Wait a while then retry.
- Stop broadcast transmission with other protocols. This
sometimes helps to avoid this problem.
Address table not
available #706 - Address table being imported/ exported from RUI.
- Address book usage doubled up with other
transmission component (Fax, etc.). - Quit access from RUI.
- Wait a while and then retry
No response #751 - Server has not booted up.
- Network disconnected. (If connection cannot be
made with transmission destination, connection is
sometimes cut mid-way.)
- Reset caused by internal error. Processing
interrupted. - Check transmission destination and network settings.
- Transmission jobs whose processing has stopped for
some reason or other are forced to quit by assigning an
internal error code (#751). As a result, after rebooting, the
job is not run.
TCP/IP error #755 - IP address set to 0.0.0.0. In the following two
situations, the IP address is 0.0.0.0.
1) Address could not be obtained from DHCP,
BOOTP, RARP.
2) Unit launched in IP fixed mode(keys 1+7 to enter
FIXIPmode).
- TCP/IP protocol stack resources insufficient. Even
with internal retry (5 times),transmission failed. - Set the IP address correctly or set DHCP, RARP, BOOTP
environments to operate properly.
- Turn power OFF/ON.
e-Signature
Certificate Access
Error #761 The encryption code used at time of PDF
transmission (bearing a user signature prepared by
MEAP authentication) prevents transmission. Install the appropriate user certificate or machine
certificate properly.
Check to see if the
address is correct. #762 e-mail is sent to an address for which transmission
is not permitted. Check to see if the target of transmission is correct.
Check to see if the domain (in user mode) is one for which
transmission is permitted.
Do not transmit to an address for which transmission has
not been authorized..
e-Certificate
Validity error #766 The period of validity of the certificate used for
signature transmission has passed. Use a certificate whose period of validity is still good.
If necessary, set the time correctly.
Check server #801 - Error generated due to cause on server side.
- SMB server side file capacity not sufficient.
- In WindowsNT/2000 server, password was
incorrect.
- In WindowsNT SMB, common file name did not
match.
- In SMB, a user exists but no write privileges.
- SMB transmission made to write-prohibited file of
the same name. - Reset server.
- Check server status and settings.
- Check the network traffic.
Cannot find server #802 DNS/SMTP setting error(DNS error) Reprogramme the user mode settings. (domain name, E-
Mail address, DNS, mail server)