Canon C200B, Инструкция по эксплуатации

Страница: 29 / 236

29
Preparing the Handle Unit and LCD Monitor
3 Align the LCD attachment unit mount to the handle unit’s front accessory mount and then use the wrench to
tighten the LCD attachment unit lock screw (
햴
).
4 Rotate the LCD monitor mount 180° toward the handle
unit ( ).
5 Using the UN-5 Unit Cable
2
, connect the camera’s
VIDEO terminal to the LCD monitor’s VIDEO terminal ( ).
2
Supplied accessory for the C200; optional accessory for the
C200B.
• Align the
Í
marks on the cables’ plugs and terminals.
• Put the cable though the LCD attachment unit’s cable
clamp ( ). If necessary, adjust the position of the
cable so that it does not get in the way of the lens.
NOTES
• Depending on the situation, the screws may become
loose. If necessary, use the hex wrench (for 0.64 cm,
1/4" screws) to tighten them.
To attach the LCD monitor to the camera
1 Set the
Q
switch to OFF.
• If the handle unit is attached to the camera, remove it.
2 Remove LCD attachment unit base 2 ( ).
• Use a hex wrench (for 0.64 cm, 1/4" screws)
1
.
1
Supplied with the HDU-2.
3 Attach LCD attachment unit base 2 to the camera (
햴
).
• Use the hex wrench to secure it firmly with the hex socket
head bolt.
4 Rotate LCD attachment unit pivot B 90° toward the SD card
slots and then rotate the LCD monitor mount 180° toward
the tape measure hook (
).