Canon C200B, Инструкция по эксплуатации

Страница: 100 / 236

Recording Audio
100
NOTES NOTES
• When shooting XF-AVC (primary or proxy) clips, the audio format is 4-channel linear PCM with an audio
sampling bit depth of 24 bit.
Selecting the Audio Input Source for Audio Channels
You can select the audio input source that will be recorded on CH1/CH2 or CH3/CH4, independently for each
pair of audio channels. For details refer to the
Audio Settings and Recorded Audio Channels table (
A
96)
.
1 Select the desired pair of audio channels.
>
[
¡ !
Audio Setup]
>
[Select CH1/CH2 Input] or [Select CH3/CH4 Input]
2 Select [INPUT Terminals] (external microphone or audio device), [MIC Terminal] (external
microphone) or [Monaural Mic] (built-in microphone) and then press the joystick.
• If necessary, repeat steps 1 and 2 to select the audio input source for the other pair of audio channels.
• For information on the monaural microphone, see About the monaural microphone (
A
103)
.
Recording a Single Analog Audio Input to Two Audio Channels
By default, when using analog audio sources (line in or microphone) connected to the INPUT terminals, each
audio input is recorded to a separate audio channel (INPUT 1 to CH1 and INPUT 2 to CH2).
If necessary (for example, as an audio backup recording), you can record the same analog audio source
connected to the INPUT 1 terminal to both audio channels, CH1 and CH2. In that case, you can adjust the audio
recording levels of each channel independently of each other.
1 Open the [CH2 Input] submenu.
>
[
¡ !
Audio Setup]
>
[CH2 Input]
2 Select the desired option and then press the joystick.
Options
[INPUT 2]: Records audio to each channel separately. Audio input into INPUT 1 is recorded to CH1, while
audio input into INPUT 2 is recorded to CH2.
[INPUT 1]: Audio input into INPUT 1 is recorded to both channels. Audio input into INPUT 2 will not be
recorded.
Operating modes: