Canon C200B, Инструкция по эксплуатации

Страница: 107 / 236

107
Waveform Monitor
8 Open the [WFM Y Position] submenu.
>
[
A
%
Assistance Functions]*
>
[WFM Y Position]
9 Select the desired percentage and then press the joystick.
* In mode, [
A !
Assistance Functions].
Options
[Line]: Sets the waveform monitor to line display mode.
[Line+Spot]: The waveform of the area in the red frame is displayed in red on top of the [Line] mode
waveform.
[Select Line]: The selected horizontal line will be displayed along with its waveform.
[Field]: Sets the waveform monitor to field display mode.
[RGB]: Functions like an RGB parade scope.
[YPbPr]: Functions like a YPbPr parade scope.
NOTES NOTES
• You can select whether to display the waveform monitor on the camera viewfinder (
k
only) and from the
VIDEO terminal, or from the SDI terminal with the
>
[
A %
Assistance Functions]
>
[WFM:
VF+VIDEO Output] (
l
[WFM: VIDEO Output]) or [WFM: SDI Output] settings.
• The waveform monitor will not be affected even if a LUT is applied to the clip’s video.
• The waveform monitor cannot be displayed while magnification is activated.
• If the [Knee] settings in the custom picture file (
A
134) were changed, a horizontal line will appear on the
waveform monitor indicating the luminance (Y) level corresponding to the knee point.
About the waveform monitor display:
• To display Canon Log 3 or Canon Log, set
>
[
!
Custom Picture/HDR]
>
[HDR/LUT] to
[HDR: Off], the other settings in the same screen to an option other than [LUT: Off], and then one of the
following:
-
>
[
!
Custom Picture/HDR]
>
[Preset] to [Canon Log 3] or [Canon Log].
-
>
[
!
Custom Picture/HDR]
>
[Gamma] to [Canon Log 3] or [Canon Log].
• To display HDR (HLG) or HDR (PQ), set
>
[
!
Custom Picture/HDR]
>
[HDR/LUT] to
[HDR: HLG] or [HDR: PQ].