Canon 3433B010, Основное руководство

Страница: 30 / 52

30
Use paper of the same type and size for adjustment as you will use for printing. •
Always make sure the loaded paper matches the type of paper speci fi ed. Adjustment cannot be
completed correctly unless the loaded paper matches the settings.
•
Always check the Adj. Priority values before using Adjust Length . •
( → "Selecting a Feed Amount Adjustment Method (Feed Priority)," User Manual)
If the Tab Selection screen is not displayed, press the Menu button. •
1
2
To ensure that lines in CAD drawings are printed at exactly the right length, use Adjust Length to adjust the
amount that paper is advanced.
Additionally, two modes are available in both AdjustmentPrint and Change Settings : A:High or B:Standard/
Draft .
B:Standard/Draft : This setting is applied when Standard or Draft is selected in Print Quality in the printer
driver.
•
A:High : This setting is applied when Highest or High is selected in Print Quality in the printer driver. •
Paper to
Prepare
Rolls •
An unused roll at least 10 inches wide
Sheets •
One sheet of unused paper of at least A4/Letter size
Perform adjustment as follows.
Load the paper.
On the Tab Selection screen of the Control Panel , press
◄ or ► to select the Settings/Adj. tab ( ).
If Line Length Does Not Match
Adjust the length of printed lines as follows.
( → , Attaching the Roll Holder to Rolls)
( → , Loading Rolls in the Printer)
( → , Loading Sheets in the Printer)
There are two options in Adjust Length : AdjustmentPrint and Change Settings .
Change Settings : No test pattern is printed. Instead, you will measure a document already printed to
determine the discrepancy.
•
AdjustmentPrint : After a test pattern is printed, you will measure the discrepancy based on the results of
printing.
•
High-precision ruler
High-precision ruler
㪏㪇㩼
Remaining Amount
Maint. cart.
Ready
OK:Setting/Adj. Menu