26
Topstone Neo Carbon OMS
27
Technical Information
Seat Tube / Seat Stay Pivot Bearings
Technical Information
Seat Tube / Seat Stay Pivot Bearings
138222 Rev 1 (03/20)
3
SS
SS
NGLI-2
2
1
2
3
5
1
4
7
SS
6
M6 x 70 mm
ST
ST
M6 x 30 mm
Seat Tube / Seat Stay Pivot Bearings
1. Bearing
2. Install Plate
3. Tool Handle
4. Remove Plate
5. Remove Cup
6. Screw M6 x 70mm
7. Screw M6 x 30 mm
ST Seat Tube
SS Seat Stay End
REMOVE
1. Remove LockR pivot hardware.
2. Insert remove plate (4) through ST pivot
so its small OD cylindrical surface engages
the inside of the bearing.
3. Insert M5X30mm screw (7) through hole
in remove plate (4) so threads are pointing
out through SS pivot end.
4. Thread tool handle (3) onto M6X30mm
screw (7) only 2-3 turns.
5. Pull SS end away from ST just enough to
allow remove cup (5) to be snapped over
M6X30mm screw (7).
6. Hold M6X30mm screw (7) stationary with
5mm hex key while turning tool handle (3)
until bearing is fully pulled out of pivot and
into remove cup.
7. Unthread tool handle to remove tool from
the frame.
8. Repeat for the other side.
INSTALL
1. Pull drive side SS end away from ST just
enough to slip larger OD side of install plate
(2) into ST pivot bore.
2. Place new bearing on smaller OD side of
2nd install plate (2).
3. Apply grease to non-drive side ST pivot
bore.
4. Pull non-drive side SS end away from ST
just enough to slip 2nd install plate (2) and
bearing into position.
5. Insert M6X70mm screw (6) through both
install plates so it’s threaded end protrudes
through SS end on non-drive side.
6. Thread tool handle (3) onto M6X70mm
screw (6) and tighten while holding screw
stationary with 5mm hex key. Tighten until
bearing is fully pressed into ST pivot bore.
7. Remove Tool handle (3), M6X70 screw (6)
and drive side install plate (2).
8. Place new bearing on smaller OD side of
install plate (2).
9. Apply grease to drive side ST pivot bore
10. Pull drive side SS end away from ST just
enough to slip install plate (2) and bearing
into position.
11. Insert M6X70mm screw (6) through both
install plates so it’s threaded end protrudes
through SS end on drive side.
12. Thread tool handle (3) onto M6X70mm
screw (6) and tighten while holding screw
stationary with 5mm hex key. Tighten until
bearing is fully pressed into ST pivot bore.
13. Unthread tool handle (3) and remove all
tools from pivot.
14. Continue with LockR axle installation
procedure.
REMOVE
REMOVE
Identification
