20
Topstone Neo Carbon OMS
21
Technical Information
Battery Charging Port
Technical Information
Front Derailleur Mount
138222 Rev 1 (03/20)
Battery Charging Port
To connect to the charger cable to the port
connector:
1. Place the bike and charger in a secure
area where both will remain undisturbed
while the battery is charging.
2. Lift up the battery port cover (1).
3. Attach the specified charging cable to the
charge socket (2).
4. When charged, disconnect charger cable
from the charge socket and replace cover.
Make sure cover is seated fully into the
frame opening.
5. Disconnect the charger from its source of
power.
Follow the drive system manufacturer’s
instructions for charging and handling the
battery.
Incorrect charging or handling can result
in a fire, an explosion resulting serious
injury or death.
Do not insert anything other than the
specified charging connector into the
charging socket.
The battery charging port is located on the left side of the bicycle at the headtube. The
charging port enables the battery to be charged while installed in the bicycle.
1
2
Front Derailleur Mount
4
5
3
2
1
4 N·m
1. FD Mount
2. Screws
3. Grommet
4. Plug
5. Di2 Plug
The front derailleur mount is a removable
“braze-on type.”
When using a mechanical FD system or
SRAM Etap, make sure the frame plug is
installed to prevent the intrusion of water or
debris into the frame.
When using Di2 Systems, use the Di2 Cable
Plug.
Rear Derailleur Mount
2
1-2 N·m
2
NGLI-2
1
3
4
1. RD Mount
2. Screw
3. Wireless
4. Di2 Plug
To replace:
Remove the rear wheel.
Remove the mounting screw(s) and remove the old
hanger from the dropout.
Clean the area around the dropout and inspect the
frame carefully for any cracks or damage. If you find
damage have the frame inspected by your
Cannondale Dealer .
If the dropout is not damaged, apply a light film of
grease between the frame and mount. This will
help minimize any noise or “creaking” that might
result from very slight movement between the
dropout and mount during movement of the
derailleur.
Slide the new hanger onto the dropout.
Clean and apply Loctite® 242 (or medium strength
thread lock) to the screw threads and tighten to the
specified torque.
