Cannon CT-500, Инструкция по эксплуатации

Страница: 13 / 49

CANNON Instrument Company | Introduction/Installation 5
•
Unless procedures specify otherwise, always turn off the unit and disconnect the MAINS cable
from the power source before performing service or maintenance procedures, or before
moving the unit.
•
Only add bath fluid to the bath when the bath temperature is within 10 °C of ambient.
• Avoid splashing liquids on the external surfaces of the CT-500, including the Pyrex® bath jar.
•
Do not obstruct the cooling vent on the top of the CT-500.
•
Always empty the bath before moving the unit.
•
Refer all service and repairs to qualified personnel.
Warning:
Hot surfaces cautions (diagram left) are attached on or near
hot surfaces of the CT-500. Avoid touching these surfaces when running
the bath at temperatures above 50 °C.
Caution: Do not attempt to service the CT-500 system by removing panels and
trying to effect repairs. Contact CANNON regarding service and repair needs.
~MAINS
The
~MAINS
symbol indicates the connections for the AC power supply. The AC
power input must match the electrical specifications of the instrument.
Never operate the equipment with a damaged MAINS AC power cable.
Use only the manufacturer-supplied MAINS AC power cable. This cable must be
inserted into a receptacle with a protective earth ground.
(O)
The
(O)
symbol indicates the OFF position for the electrical switches for your
unit.
Operator Safety
All technicians who use the CT-500 should follow these basic safety procedures:
• The CT-500 power cord should only be connected to a suitable AC MAINS power source (with
protective earth ground) matching the specifications of the S/N label on the CT-500 rear panel.
• Place the CT-500 on a stable laboratory table or bench. If any liquids are spilled in or around
any electronic components of the CT-500, remove power and contact Cannon Instrument
Company before introducing power to the system again.