16
Step 4: Determine the length of wire needed to pass from the Surge Protector to the ICT
Fence Transmitter. Measure and cut the length of twisted pair wires, then strip
approximately 3/8-inch of insulation at both ends.
Step 5: Insert the ends of the transmitter wires into the right 2 black connectors at the
bottom of the Surge Protector labeled “Transmitter”.
Note: There should be 1 wire in each connector hole.
Step 6: Insert the opposite stripped ends of the two transmitter wires (Described on Page
17, Step 2 of ICT Transmitter Installation) into the connectors for the appropriate loop on
the ICT Transmitter.
CAUTION: Verify the boundary and transmitter wires are connected to the proper
Surge Protector terminals. Damage to both the Surge Protector and your Fence Transmitter
can occur if connections are reversed.
ICT Transmitter Installation
1.
After your LP4200 has been installed, Mount your ICT Transmitter to the wall using
(3) 1 ¼” Drywall screws (or if mounting to a concrete wall, use 1¼” Concrete
screws).
