18
Before installing the hob :
make sure that the appliance is compatible with the gas supply source.
The hob is pre-set in the factory to work with the type of gas shown on the packing
and the plate attached to it.
Natural gas G 20-20 mbar / G 25-25 mbar : mains gas
if necessary, adapt the hob for use with another type of gas : if the hob must be
used with another type of gas than the gas pre-set in the factory, it is necessary to
adapt the hob gas burners (page 19).
The procedure for adaptation consists of :
. fitting the correct jets to ensure nominal delivery.
For installation,
built-in hob (page 20).
make the gas connection according to the type of gas to be used : based on
the gas to be used, choose the appropriate gas connection (page 21).
make the hob electrical connection according to the instructions (page 22).
adjusting the minimum flame of the taps : if necessary, adjust the minimum flame
of the taps by turning the by-pass screw (page 23).
INSTALLATION
Installing a domestic appliance can be a complicated operation which if not carried out
correctly, can seriously affect consumer safety.
It is for this reason that the task should be undertaken by a professionally qualified
person who will carry it out in accordance with the technical regulations in force.
In the event that this advice is ignored and the installation is carried out by an unqualified
person, the society declines all responsibility for any technical failure of the product
whether or not it results in damage to goods or injury to individuals.
All modification concerning the hob gas setting must be indicated on the rating
plate of the hob.