C&T Solution CT-MCL01 Series, Руководство пользователя

Страница: 40 / 72

CT-MCL01 l User’s Manual
40
2.6 OEM full screen logo
BIOS support the following format OEM full screen logo and user can insert it by utility that provided from
BIOS vendor.
BMP :800x600 24bits, JEPG:800x600 24bits, PCX:800x600 24bits
2.7 SuperIO Feature Support
Chapter 2: BIOS Setup
SuperIO Feature Support
Item Description Remarks
Serial Port
•
Each UART includes a 128-byte send/receive FIFO, a programmable
baud rate generator, complete modem-control capability, and a
processor interrupt system.
•
The UART supports legacy speeds up to 115.2K bps as well as even
higher baud rates of 460K, or 921K bps to support higher speed
modems.
•
Default
COM1=3F8/IRQ4,COM2=2F8/IRQ3,COM3=3E8/IRQ5,COM4=2E8/IR
Q5,COM5=2E0/IRQ10,COM6=3E0/IRQ10
Case Open
•
The purpose of Case open function is used to detect whether the
computer case is opened.
•
This feature must be able to function even when there is no 3VSB
power.
•
Once the case is opened, the beep will be active at next boot. The
buzzer works and show error message will stop at post screen by
press Del until user disables the function in BIOS setup.
Watchdog
•
BIOS provide 0 to 255 seconds or minutes watchdog reset function.
•
If user set to 0, it will disable watchdog function.
•
If user writes any non-zero value to this register causes the counter
to load this value into the Watchdog Timer counter and start
counting down. System will be reset if Watch Dog Timer counts
down to zero.
Brightness
Control
•
BIOS provide DC output to control panel brightness.
•
The brightest DC output generally. But it still dependent on
hardware design or inverter of panel.
Smart Fan
•
BIOS provide CPU and System smart fan function for noise
consideration.
•
Depend on Super IO support Manual, Thermal Cruise, SMART FAN
IV and Disable mode.