pg. 9
5. MOUNTING FAN ASSEMBLY
INSTALLATION
• loosen two screws and washers (B) on mounting bracket which correspond
with the slots in the canopy
• remove two screws and washers (A) on the mounting bracket which
correspond with the oblong holes in the canopy.
• position the canopy to the mounting bracket, aligning slots to the screws (B)
then twist to lock
• position and tighten two screws and washers (A) then tighten the two screws (B)
A
B
B
A
pg. 10
6. MOUNTING BLADE BRACKETS TO BLADES
INSTALLATION
A. “DIECAST” BLADE BRACKETS
• obtain hardware package containing blade bracket screws and washers.
• place fibre washer over screw.
• place screw through blade hole and slip a rubber washer over the screw.
• align screw with blade bracket and secure.
• repeat for other two screws.
• once all blade brackets are attached to blades double check that screws are tight.
NOTE:
Rubber washers only supplied on those fans with high gloss blades
B. “MEDALLION STYLE” BLADE BRACKETS
• obtain hardware package containing blade bracket screws and washers.
• place fibre washer over screw.
• place rubber washers in holes of blades.
• position bottom blade bracket and top blade bracket with blade.
• start screws and fibre washers by placing into top blade bracket and blade
and threading into the bottom bracket.
• tighten screws only after the 3 screws have been started and blade brackets
are straight on the blades.
blade bracket screw
blade bracket
blade
fibre washer
rubber washer
fibre washer
blade bracket screw
blade
bottom
blade bracket
top
blade bracket
rubber washer
