T H U N D E R B A Y S E
Configuration: Your Control Centre
JETS 1
Activates Jet 1
TEMP UP
Increase Temperuture
Select / Light
Enter & Lights
On / Off
JETS 2 / Blower
Activates Jets 2 /
Blower
TEMP DOWN
Decrease Temperature
INVERT
Inverts Display
Button Functions
TEMPERATURE UP
TEMPERATURE DOWN
FLIP (INVERT DISPLAY)
Press the dedicated Flip/Invert button. Allows the user to flip the display with a single button press.
JETS
Press the “Jets 1” button once to turn pump 1 on or off, and to shift between low and high-speeds. If left run-
ning, the pump will turn off after a time-out period. The pump 1 low-speed will time out after 30 minutes. The
high-speed will time out after 15 minutes.
The low-speed of pump 1 runs when the pump is on. If the spa is in Ready Mode Pump 1 low may also acti-
vate for at least 1 minute every 30 minutes to detect the spa temperature (polling) and then to heat to the set
temperature if needed. When the low-speed turns on automatically, it cannot be
deactivated from the panel, however the high speed may be started. Press Jet 2 and same as above.
JETS 1, JETS 2
LIGHTS
Press light button to turn on and off the lights. Each consecutive press will alternate through different lighting
modes and colours.
PRESS TO CHANGE LIGHT SETTINGS
ADJUST TEMPERATURE
When using a panel with Up and Down buttons (Temperature buttons), pressing Up or Down will cause the
temperature to flash. Pressing a temperature button again will adjust the set temperature in the direction
indicated on the button. When the LCD stops flashing, the spa will heat to the new set temperature when
required. The temperature can be set between 60°F (15 °C) and 104°F (40 °C).
PRESS-AND-HOLD
If a Temperature button is pressed and held when the temperature is flashing, the temperature will continue to
change until the button is released.
(17)
