CAN PC Series, Инструкция по эксплуатации

Страница: 40 / 48

40
INSTALLATION
– MAINTENANCE – ADJUSTMENTS
The information and operations illustrated in this section are dedicated exclusively to fitters.
The installation and all adjustments, transformations and maintenance operations shown in this section must be carried
out exclusively by qualified personnel, in observance of local legislation
(Law no. 46/90 and DPR 447) .
If in doubt, contact Technical Assistance.
Incorrect installation or adjustment may cause damages to people, animals or things. The manufacturer declines all
responsibility for installation or adjustment which do not comply with the instructions given in this section.
Installation must conform to UNI 7131 (the latest revision).
Inserting and fastening the appliance
Remove the appliance from the packaging, ensuring that it is complete and undamaged. If in doubt, do not proceed and contact
the dealer of Technical Assistance immediately.
Remove the protective plastic.
The material of items adjacent to the appliance (furniture( must resist temperature surges of at least 65 K (90°C with a room
temperature of 25 °C).
Make a hole in the surface of the unit in which you wish to install the appliance.
Also observe the critical distances from the adjacent walls/furniture.
Hole size (W x D) to house the appliance and critical distances (X and Y) vary from model to model. See table and figure 3 below.
N.B.: In figure 3, the side of the furniture is shown to the left of the appliance. If you wish to install it on the right, observe the same
critical distances indicated in the table (Y).
Make sure that the distance between the pan stand of the appliance and any furniture of hoods above the appliance is at least 650
mm.
Any lateral work surfaces within critical distance Y must remain below the height of the appliance surface.
When the appliance is in use the bottom may feel hot, while remaining within the limits indicated by the reference standard ( EN
30). To prevent accidental contact it is possible to install a divider (separator panel) at least 20 mm (but not more than 150 mm)
from the bottom of the appliance.
Before inserting the appliance, connect the gas as described in the following pargraphs.
Model W (mm) D (mm) X (mm) Y (mm)
PV 1350
185 350 55 100
PV 1351
360 260
55 100
PV 1352
400 370
55 100
PV 1357
280 480
75 100
PV 1360
580 400
55 100
PV 1361
780 400
55 100
Figure 3
The appliance must be fastened to the unit using
M.S.SUPER (fratelli zucchini) silicone or equivalent.
If you wish to install the appliance flush with the unit, it is necessary to mill ( 1 cm wide, 1 cm deep ) the hole cut into the unit.
To fasten the appliance, apply a strip of silicone along the underside edge of the glass Insert the appliance into the hole in the unit,
pressing it down gently until the silicone hardens
(at least 3 hours) .
The appliance is now fastened to the unit. For any maintenance operations requiring the dismantling of the appliance from the unit,
cut the silicone using a cutter. Before re-fastening the appliance, clean any silicone from the glass of the appliance and the hole in
the unit.