CAN PC Series, Инструкция по эксплуатации

Страница: 17 / 48

17
Figure 2 b): spartifiamma
Figure 2 c): cappellotto (retro)
The burner parts that can be dismantled for ordinary cleaning are the cap and flame divider. Do not use tools to dismantle the
parts. The removal of other burner parts is forbidden.
When cleaning the cut-off device, operate gently using a wet sponge.
The removal of parts of the appliance other than the burners (within the limits indicated above) or the pan restraint accessories is
forbidden.
INSTALLATION
– MAINTENANCE – ADJUSTMENTS
The information and operations illustrated in this section are dedicated exclusively to fitters.
The installation and all adjustments, transformations and maintenance operations shown in this section must be carried
out exclusively by qualified personnel, in observance of local legislation
(Law no. 46/90 and DPR 447) .
If in doubt, contact Technical Assistance.
Incorrect installation or adjustment may cause damages to people, animals or things. The manufacturer declines all
responsibility for installation or adjustment which do not comply with the instructions given in this section.
Installation must conform to UNI 7131 (the latest revision).
Inserting and fastening the appliance
Remove the appliance from the packaging, ensuring that it is complete and undamaged. If in doubt, do not proceed and contact
the dealer of Technical Assistance immediately.
Remove the protective plastic.
The material of items adjacent to the appliance (furniture( must resist temperature surges of at least 65 K (90°C with a room
temperature of 25 °C).
Make a hole in the surface of the unit in which you wish to install the appliance.
Also observe the critical distances from the adjacent walls/furniture.
Hole size (W x D) to house the appliance and critical distances (X and Y) vary from model to model. See table and figure 3 below.
N.B.: In figure 3, the side of the furniture is shown to the left of the appliance. If you wish to install it on the right, observe the same
critical distances indicated in the table (Y).
Holes for passage of the fastening pins
hole for passage of the cut-off device
recesses for coupling with fastening
pins