CAN PC Series, Инструкция по эксплуатации

Страница: 31 / 48

31
Restore any seals when the replacement operation is complete.
If it becomes necessary to replace the injectors, see the TECHNICAL FEATURES section. No sealant is used between the injector
thread and its seat.
Figure 4
Proceed with reassembly.
Greasing the valves: if the rotation of the knob becomes difficult, it is necessary to grease the valve to prevent damage. Proceed
as follows:
- dismantle the valve from the gas ramp and the internal tubes;
- dismantle the body of the valve;
- remove the conical male element, cleaning it with thinner;
- lightly re-grease the cone using appropriate grease;
-
introduce the cone into its seat, manoeuvring it to expel any excess grease. Remove the excess grease with a cloth;
- remove the cone again to ensure that the grease has not blocked the internal gas passages;
- refit the valve.
AFTER COMPLETING EACH REASSEMBLY, ALWAYS CHECK THAT THE SEAL CONFORMS TO THE INSTALLATION
STANDARDS IN FORCE.
THE USE OF A NAKED FLAME IS STRICTLY FORBIDDEN.
TECHNICAL FEATURES
Installation class: 3
Fastening method:
screws
Appliance category: *
Gas (group) and supply pressure: *
Total burner power (

Q
n
): *
* see the plate on the first page, in accordance with the country of destination
Cut-off device
Stainless steel ramp
Injector cup
Copper ramp
valve