Camsat iCAM-Mobile HD II, Руководство пользователя

Страница: 8 / 44

3. iCAM-MobileHD system installation
3.1. First start-up
Before first start-up, check whether the set is complete and whether the device has not
been mechanically damaged during transport.
WARNING
Before any start-up, connect both antennas! Trying to run the machine without
connected antennas may cause damage to the radio module.
3.2. IP camera installation
(in case without IP camera)
The configured IP camera should be connected to the twisted pair that protrudes from
the housing of the 4G LTE radio module, and the whole cable should be placed in the ca-
mera holder.
Then attach the camera to the holder on the front
cover of the device. The entire cable coming out
of the camera must be in the camera holder, do
not place it in the case.
IP Camera factory settings
Standard Onvif
IP address 192.168.1.108
Onvif port 80
Username admin
Password admin
In order to extend the device's operating time on the battery,
you can turn off the heater in the camera if it has one.
The configured IP camera should be connected to the twisted
pair that protrudes from the device housing, and the whole
cable should be placed in the camera holder.
Then attach the camera to the holder on the front cover of the device. The entire cable
coming out of the camera must be in the camera holder, do not place it in the
iCAM-Mobile housing.
Page 8
Spacing of mounting holes