1
11
Visit Us: Camplux.com
3330-A Marathon Ct Charleston, SC 29418
(844) 538-7475
Getting Started
1. Check carton box for damage. Damages caused in shipment must be reported
immediately. Please contact us on our support page at www.camplux.com or
give us a call at (844)538-7475.
2. Make sure you have all the parts.
NOTE: Included parts and accessories may vary depending on country and
regulations.
(
Please refer the alphabetical letter below to page 13 to ensure all items are
included.)
A. Camplux outdoor portable tankless gas water heater
B. ON/OFF switch shower head with 5 feet red hose and snap on connector
C. CSA certified gas regulator with 5 feet hose
D. Gas compression fitting *fixed to gas inlet already*
E. 1/2” BSP female X 3/4” GHT male, 1/2” BSP female X 3/4” GHT female
garden hose adapter
F. Hardware pack
G. Wrench set
3. If using a standard garden hose, attach the 3/4” GHT garden hose adapter to
the fitting marked “Water Inlet”. Check to make sure the filter inside the water
inlet is in place and clean. Then attach your water inlet/garden hose.
4. Install gas supply line and regulator to the portable tankless water heater with
included wrench set. DO NOT OVER TIGHTEN. OVER TIGHTING MAY
CRACK THE GAS REGULATOR CAUSING A GAS LEAK! Check for any gas
smell before ignition! Make sure it is tightened all the way on.
5. Attach shower hose to the fitting marked “Water Outlet”. Do not over tighten.
6. Install 2 size D batteries in the compartment on the bottom left of the heater.
Check that batteries are facing the correct direction.
7. Use the top tab on the portable tankless water heater to suspend from a
mounted screw. Place at a comfortable height without putting stress on the
gas hose.
8. Connect gas regulator and gas inlet brass fitting by wrenches with torque force
between 20-28N/m.