Campbell WXT520, Инструкция по эксплуатации

Страница: 20 / 24

Appendix A. Configuring the WXT520
A-2
6. Go to the Device Settings Screen and enter the settings for each of the
parameters (see FIGURE A-2 ). Default settings are:
• Device—Address: 0
•
Heating and self diagnostic—verify Enable Heating is NOT
selected.
• Heating and self diagnostics—Update Interval: 15 s
• Communication protocol—select SDI-12 v1.3
•
User port settings—Port type: SDI-12, select continuous
measurements
FIGURE A-2. Device Settings screen
7. Click on the OK button.
8. Go to the Sensor Settings Screen (see FIGURE A-3 ). The default Wind
and PTU Update intervals are set to 5 s.