Campbell NL241, Инструкция по эксплуатации

Страница: 66 / 76

Appendix C. NL241 Settings
C-12
CS I/O TCP Timeout
This setting, in units of seconds, will determine how fast the CS I/O serial
server will time out if no activity is detected. Set to
0
for no time-out (not
recommended) (range 0 to 999).
CS I/O PakBus Beacon Interval
This setting, in units of seconds, governs the rate at which the NL241 will
broadcast PakBus® messages on the CS I/O port in order to discover any new
PakBus neighboring nodes. It will also govern the default verification interval
if the value of the CS I/O Verify Interval setting is set to 0 .
CS I/O PakBus Verify Interval
This setting specifies the interval, in units of seconds, that will be reported as
the link verification interval in the PakBus® hello-transaction messages. It will
indirectly govern the rate at which the NL241 will attempt to start a hello
transaction with a neighbor if no other communication has taken place within
the interval.
CS I/O Modbus Timeout
This setting determines how long, in milliseconds, the MODBUS/TCP to
MODBUS/RTU gateway will wait for an answer from the MODBUS slave
device(s) attached to the CS I/O port. If no answer is received within the
timeout period, the MODBUS/TCP server will reply to the MODBUS/TCP
client with error code 0x0B (Target Device Failed to Respond).
C.5 Net Services Tab
Telnet
Enables/Disables the telnet service.
Telnet Port Number
The default TCP port number for the configuration monitor telnet session is 23.
This entry makes it possible for the user to change the telnet session port
number if desired. Typically, it is not necessary to change this entry from its
default (range 1 to 65535).
Telnet Timeout
This setting, in units of seconds, will determine how fast the configuration
monitor telnet session will time out if no activity is detected. Set to 0 for no
time-out (not recommended) (range 0 to 999).
Ping (ICMP)
The NL241 will not respond to Ping requests if this setting is disabled.