Campbell NL241, Инструкция по эксплуатации

Страница: 29 / 76

NL241 Wireless Network Link Interface
19
11. Configure the NL241 as needed for your application.
12. Click Apply to save your changes.
7.3 Configuring the NL241 with Telnet via Wi-Fi WLAN
For security reasons, Telnet is disabled by default. It must be
enabled from the Network Services tab in DevConfig .
The NL241 must have an IP address before connecting via Telnet.
Configuration via Telnet is not available in bridge mode.
1. Ensure the NL241 is powered and connected to your network.
2. Create a telnet session with the device over port 23.
3. Type the NL241 admin password (default password is NL241 ).
4. Type help to see a list of the functionality available when connected to the
NL241 through Telnet.
5. Type
edit
and press
Enter
to edit the settings of the NL241.
6. As each NL241 setting is shown, press Enter to accept the current value
shown in parenthesis. Type a new value and press Enter to change the
value. The up and down arrow keys on your keyboard can also be used to
navigate through the settings.
7. After progressing through all of the NL241 settings, type save to accept
the changes or cancel to discard the changes.
8. Type bye to exit the telnet session.
7.4 Configuring the NL241 via RS-232
Accessing the configuration terminal menu via RS-232 requires
the NL241 to be power cycled, so physical access to the device
will be required. A null modem serial cable will be needed; one is
not provided with the NL241.
1. Using a null modem serial cable, connect your computer’s serial port to
the
RS-232
port on the NL241.
2. Connect to the NL241 using a terminal emulator. The DevConfig
“ Unknown ” device type or HyperTerminal are examples of simple
terminal emulators. The default settings for this interface are 115200 baud,
8 data bits, no parity, 1 stop bit, no flow control.
3. Power cycle the NL241 and repeatedly press Enter at the terminal.
4. Type help to see a list of the functionality available when connected to the
NL241 through Telnet.
NOTE
NOTE