Campbell NL241, Инструкция по эксплуатации

Страница: 30 / 76

NL241 Wireless Network Link Interface
20
5. Type edit and press Enter to edit the settings of the NL241.
6. As each NL241 setting is shown, press Enter to accept the current value
shown in parenthesis. Type a new value and press
Enter
to change the
value.
7. After progressing through all of the NL241 settings, type save to accept
the changes or cancel to discard the changes.
8. Disconnect your computer and power cycle the NL241.
8. Operation
This section describes how to configure the Wi-Fi connection and operational
mode of your NL241. See Section 6 , Wi-Fi
(p. 13)
, for more information about
the types of Wi-Fi connections available. See Section 4 ,
Overview
(p. 7)
, for help
in determining which operational mode to use.
8.1 Wi-Fi Connection
8.1.1 Join an Existing Network
In this configuration, the device will scan for available networks and attempt to
join the network (infrastructure or ad hoc) specified by the SSID setting.
1. Connect to the NL241 in
DevConfig
(see Section 7 ,
Configuring the
NL241
(p. 17)
).
2. Click the Wi-Fi tab.
3. Set Configuration to Join a Network .
4. Press the browse button next to the Network Name ( SSID) field to see a
list of the available networks in the area. Select the network you wish to
connect to and click OK . If the Network Name ( SSID) field is left blank,
the device will attempt to join the strongest unsecured network it finds.
5. If this is a secured network, enter the password in the Password field.
6. Click
Apply
to save your changes.
If for some reason the device cannot join the desired network (for
example, out of range or incorrect parameters), it will go to a low-
power state and periodically retry to join the network
approximately once every minute. If the device has successfully
joined a network and then detects a loss of connectivity with the
network, it will begin periodically searching for the network at
approximately the one-minute interval.
NOTE