Campbell LS300G, Инструкция по эксплуатации

Страница: 48 / 56

Appendix E. LS300G Settings
E-2
Modems IP Address (read only)
Reports the IP address currently assigned to the modem by the cellular
network. This value will always be assigned by the network. In the case of a
static IP address, the network will issue the same address each time that the
modem connects.
E.2 Settings Tab
RS-232 Baud Rate
Sets the bit rate used by the RS-232 Port.
APN
Specifies the Access Point Name (APN) that will be used on the mobile
network.
An APN is the name of a gateway between a GPRS, 3G or 4G mobile network
and another computer network, frequently the public Internet. A mobile device
making a data connection must be configured with an APN to present to the
carrier.
I2GOLD (an AT&T® APN) is a special purpose APN primarily used when the
functionality is needed to push data, meaning the device can receive unsolicited
packets from the Internet. This APN also includes a static IP address. Use of
this APN is limited to 30 devices. A Custom APN is required if you have more
than 30 devices.
Device Port
Specifies the TCP port number used for serial server communication on the
modem’s RS-232 connector. This value will be set to 3001 when using Load
CSI Settings
.
KeepAlive Ping Interval (Min)
Specifies the interval, in minutes, at which the modem will send ICMP ping
messages in order to test network connectivity. If a value of zero is specified,
the modem will not send ping messages. If set to a value greater than or equal
to 15, the modem will send ping messages at that interval. This value will be
set to a default of 0 when using Load CSI Settings .
Diversity Antenna
This setting is use to enable the diversity antenna. When a single antenna is
used, the diversity antenna should be disabled. When using Load CSI
Settings , this is set to Disabled .
E.3 Dynamic DNS Tab
Modem Name
Specifies the name of the modem used with the eairlink.com DDNS IP
Manager server. The modem name needs to be a unique name with the eairlink