Campbell LS300G, Инструкция по эксплуатации

Страница: 10 / 56

LS300G GSM/GPRS/EDGE/HSPA+ Sierra Wireless Cellular Modem
2
4. Quickstart
4.1 Establish Cellular Service
What you need:
• AT&T® GSM/GPRS/EDGE/HSPA+ coverage at the datalogger site
(for a coverage map refer to: www.wireless.att.com/coverageviewer )
•
GSM/GPRS/EDGE/HSPA+ business account established with
AT&T®
To set up a GSM/GPRS/EDGE/HSPA+ business account, contact your
AT&T® Business Account Representative or Blu-Telecommunications.
Blu-Telecommunications is part of the Alliance Channel with AT&T® and can
assist any customer nationwide. Blu-Telecommunications will contact
AT&T® and work with an AT&T® account manager to set up an account.
Contact information for Blu-Telecommunication:
Phone number: (877) 422-2616, or Email box: i2gold@blu-tel.com
What to ask for: M2M Setup
Who to ask for: Carlos Morales or Andy Tran
An Access Point Name (APN) must be added onto the account to make the
modem accessible through the Internet. For networks with fewer than 30
modems, the standard ‘I2Gold APN’ can be used; networks with more than 30
modems will require a ‘Custom APN’. A Custom APN has a setup fee starting
around $500 and takes a minimum of 7 to 14 business days to complete. The
user must program the APN name into the modem as described in Section 4.3 ,
Configure LS300G
(p. 3)
.
AT&T® will provide a Subscriber Identity Module (SIM) card for each
modem. The SIM card must be installed inside of the modem as described in
Section 4.2 , Install the SIM Card
(p. 2)
. In addition to the SIM card, you should
receive:
• 10-digit MSISDN number (telephone number associated with the
SIM, used for billing)
•
IP Address and APN for GSM/GPRS/EDGE/HSPA+ service
4.2 Install the SIM Card
The SIM in the LS300G is a smartcard that securely stores the key identifying
a mobile subscriber. You will only need to install the SIM once in the life of
the modem.
To install the SIM card:
1. Remove the SIM card cover.
2. When viewed from the top, the notched corner of the SIM card faces
towards the center of the device as shown in FIGURE 4-1 . Gently
slide the card into the slot in the connector until it stops.