Campbell LS300G, Инструкция по эксплуатации

Страница: 11 / 56

LS300G GSM/GPRS/EDGE/HSPA+ Sierra Wireless Cellular Modem
3
3. Replace the SIM card cover.
FIGURE 4-1. SIM card installation
4.3 Configure LS300G
Quickstart describes configuring the LS300G in serial server
mode. It may also be configured in Point-to-Point Protocol (PPP)
mode. For a description of the modes, see Section 5 ,
Overview
(p.
8)
. For instructions on setting up the LS300G in PPP mode, see
Section 7.5 , AceManager and Template Files
(p. 16)
, and Section
7.6 ,
Enabling PPP Mode
(p. 19)
.
The LS300G setup for serial server mode may be done with the Device
Configuration Utility (DevConfig)
version 2.09 or later.
DevConfig
may be
updated/downloaded at no charge at www.campbellsci.com/downloads . (The
LS300G can also be set up in serial server mode using template files. See
Section 7.5 , AceManager and Template Files
(p. 16)
.)
Connect a serial cable (for example, USB-to-serial, CSI pn 17394) between the
PC and the 9-pin serial port on the LS300G.
Open DevConfig (either from the PC’s Start menu or by clicking the icon
within LoggerNet ) and select LS300 from the Cellular Modem group in the
left panel.
NOTE