CRVW3 3-Channel Vibrating-Wire Datalogger
75
Mode
is set to
Point to Multipoint Slave
. Press
Apply
if necessary. See
, if the station is a repeater.
Ensure that the
Radio Enabled
setting is set to
True
. The
Radio ID
setting
should be a unique number for every device on the RF451 network (end-node,
repeater, and base station). Often it is convenient to set it to the same number
as the PakBus Address, though that is not required. Every device on the
network should use the same
Frequency Key
and the same
Network ID
. To
understand how to use the other settings on the
Radio
and
Radio Advanced
tabs, refer to the topical help in
DevConfig
, or to the RF451 manual
s.campbellsci.com/documents/us/manuals/rf451.pdf
While on-site, use a portable (temporary) RF451 device configured as the
master radio and connected to
LoggerNet
running on a laptop to confirm proper
radio operation of the station. (See Section
(p. 74)
(p. 80)
.) Connect to
the station and collect data.
10.4.2 CRVW3-RF407 Deployment
When the CRVW3-RF407 is deployed as an end-node in the network, ensure
that is configured correctly using
DevConfig
(p. 69)
.) From the
Settings Editor
tab in
DevConfig
,
choose the
Radio
tab.
Содержание CRVW3
