![background image](http://html1.mh-extra.com/html/campbell/clarivue-10/clarivue-10_product-manual_3781804022.webp)
8. Type SDI12 and press Enter.
9. At the Select SDI12 Port prompt, type the number corresponding to the control port where
the sensor is connected and press Enter. In this example the sensor is connected to C3. The
response Entering SDI12 Terminal indicates that the sensor is ready to accept SDI-12
commands.
10. Type ?! to determine the address of your sensor. The default sensor address is 0.
NOTE:
If the standards are cold or the sensor was recently removed from the water, the
ClariVUE 10 will need to equilibrate to the ambient temperature before doing the next
step.
11. Submerge the ClariVUE 10 into the first calibration standard or DI water. Place the sensor
vertically, in the middle of the calibration cup. If the first point is DI water or a turbidity
standard less than 20 TU, use a black 8 liter (2 gallon) bucket, preferably tumbled so the
inside of the bucket is not glossy/reflective.
ClariVUE™10 Side-Scatter Turbidity Sensor
19