FT-29 Palazzo Obelisk Fountain
Assembly Instructions
Three people are recommended for the installation of this fountain!
Assemble your fountain on a level surface capable of holding a minimum of 1,135 lbs with an
approximate 14 sq. ft. footprint (actual dimensions 45" x 45").
Step 1 - Place the basin (FT-29C/30D) into position where the fountain will be installed, ensuring
that it is level.
Step 2 - Assemble the pump kit
2a - Connect the 3/4" clear tubing of the preassembled tubing to the pump by sliding it
over the pump adapter
2b - Place the stopper around the pump cord approximately 8 inches from the pump.
Step 3 - Feed the pump cord through the hole in the basin (FT-29C/30D) and the channel.
Step 4 - FIRMLY press the stopper into the hole evenly.
4a - Note: Using the handle of a screwdriver or hammer works best to press the stopper
in place.
FT-29C/30D (579 lbs)
45"L x 45"W x 11"H
Fountain Set-Up:
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Step 5 - Place the pump cover (FT-29B/30C) over the pump. Ensure it is placed properly
and leveled.
BOTTOM OF COLUMN (FT-29B)
Step 6 - Using hose clamps, secure the 2 open ended 6" pieces of non-kink tubing to the 2 pipes
protruding from the bottom of the column (FT-30B).
Step 7 - Center the column (FT-29B) on top of the pump cover (FT-29B/30C).
INSIDE OF COLUMN (FT-29B)
Step 8 - Use a hose clamp to attach the 18" length of non-kink tubing to one of the two pipes
protruding on the inside of the column (FT-30B).
FT-29B/30C (52 lbs)
12"L x 12"W x 8"H
FT-29B (65 lbs)
12"L x 12"W x 12"H
