FIG. 6
WARMING RACK AND COOKING GRATE
1. Install the cooking grate as shown in Fig 7.
FIG.7
CLEAN-OUT KNOB ASSEMBLY INSTALLATION
Hand tighten the burner clean-out knob as shown in Fig 8.
PG24-9 (1)
BURNER PULLOUT KNOB
FIG. 8
CLEAN-OUT PORT KNOB
1. Clean-out Port knob must be pushed in when grill is on.
Make sure pullout lock is pushed down and locks the
knob to prevent inadvertent opening of the clean-out port.
See Fig 9.
FIG. 9
2. Lift pullout lock and pull clean-out port knob to empty
ash into ash cup. See Fig 10.
3. See instructions for burner clean-out.
FIG. 10
BURNER CLEAN-OUT
Before each use the burner should be cleaned out by lifting
the pullout lock and pulling the clean-out port knob on the
left side of the grill to open the burner clean-out. This will
allow the ash from previous use to fall into the cup under
the grill. The cup should be removed and emptied and then
reinstalled before each use.
SHELF BRACKET AND SHELF ASSEMBLY INSTRUCTIONS
1. Install the 2 shelf brackets using M6 x 12MM Button
Head Screws and 6MM lock washers as shown in Fig.11.
Check width of brackets with shelf before tightening
hardware.
FIG. 11
2. Tighten all hardware.
3. Assemble side shelves by inserting hook over the bottom
rod of the brackets. Lift shelf up and rotate into upper
rod. Press shelf down to lock into position as shown in
Fig.12.
FIG. 12
