PIZZA STONE:
Install stone on top of wire rack in oven as shown.
WARNING
All leak tests must be performed outdoors in a well vented
area only and away from ignition sources such as gas fired or
electrical appliances. During leak test, keep away from open
flames or sparks.
SETUP USING DISPOSABLE BOTTLE
1. Make sure burner valve is off.
2. Remove plastic cap from top of propane cylinder. Save cap
for use in storing. Screw propane cylinder into regulator. Be
careful not to cross thread. Hand Tighten only.
3. Check the connection between the cylinder and the regulator
with soapy water. Bubbles indicate a leak. Check that the
connection is not cross-threaded and that it is tight. Perform
another leak check. If there is still a leak, remove the cylinder
and contact the manufacturer for service or repair.
4. The regulator uses a threaded fitting to attach to the stove.
It is necessary to hold the oven to make sure the fitting is
seated. Align the regulator to the fuel tube on the rear of the
oven and push on. Screw on the outer threaded sleeve in a
clockwise direction until tight. Perform leak check at
this connection.
5. Never operate oven with propane cylinder in an
inverted position.
1. DO NOT leave this appliance unattended while in use. The
user must remain in the immediate area of the product and
have a clear view of the product at all times
during operation.
2. Keep children and pets away from burner at all times.
3. The use of alcohol, prescription or non-prescription drugs
may impair your ability to properly assemble or safely
operate this appliance.
4. For OUTDOOR use only. Do NOT use in a building, garage or
any other enclosed area. Do NOT use in or on recreational
vehicles or boats. This appliance is not intended for and
should never be used as a heater.
5. Do not operate appliance under ANY overhead construction.
Keep a minimum clearance of 1 foot (0.3 m) from the sides,
front and back of appliance to ANY construction. Keep the
area clear of all combustible material and flammable liquids,
including wood, dry plants and grass, brush, paper, and
canvas. Never use this appliance within 25 ft. (7.5 m) of
any flammable liquid.
6. Use ONLY on a level, stable surface.
7. Keep the fuel supply hose away from any heated surfaces.
8. To prevent accidental fires, before using the appliance
ensure that the hose is not damaged and all joints and
connections are not leaking by turning on the cylinder valve,
leave the burner valve closed, and apply a soapy solution to
the joints and connections. If a continuous hissing sound is
heard, or if the soapy solution bubbles, there is a leak. Do not
use the appliance if there is a leak. Replace the faulty parts.
9. Extinguish all open flames before connecting the gas supply to
the appliance and before checking for leaks.
10. Do NOT move the appliance when in use. Allow unit to cool to
115°F (45°C) before moving or storing.
11. This appliance will be hot during and after use. Use
insulated oven mitts or gloves for protection from
hot surfaces.
12. In case there is a fire, call the local fire department or dial
911. Stay clear from flames. Do not attempt to extinguish
an oil or grease fire with water.
13. This product is not intended for commercial use.
14. Do not obstruct the flow of combustion and ventilation air.
NOTE: This appliance is set to use 16.4 oz. disposable
propane cylinders. Use only cylinders marked propane.
Disposable propane cylinders must be disconnected from the
stove when it is in storage.
Refillable Bulk LP-Gas Tanks with a maximum capacity of
20 pounds may also be used with an optional bulk tank
adapter hose. (Bulk tank adapter hose may not be included)
Refillable propane gas cylinders must be turned off at the
LP-Gas supply cylinder when the stove is not in use.
The LP-gas cylinder(s) used with this stove must be
constructed and marked in accordance with the specifications
for LP-gas cylinders of the U.S. Department of Transportation
or Transport Canada, CAN/CSA B339.
ASSEMBLY INSTRUCTIONS:
THERMOMETER INSTALLATION:
Remove nut from bottom of thermometer. Install themometer thru
the hole in the top of the oven as shown. Attach nut from inside
of the oven and tighten.
HANDLE INSTALLATION:
Attach handle to door as shown using Qty 2 screws.
SHELF INSTALLATION:
Install shelf as shown. Make sure bracket on back of shelf
pushes all the way down on the front edge of the oven. Install
Qty 2 screws through brackets as shown.
DISMANTLING DISPOSABLE PROPANE CYLINDER
1. Turn all valves to the off position and make sure all flames
are extinguished.
2. Remove the bottle from the regulator by turning
counter-clockwise.
• Use appliance only with LP (propane) gas and the regulator/
valve assembly supplied.
• Installation must conform with local codes, or in their absence
with National Fuel Gas Code, NFPA 54/ANSI Z223.1 or CSA
B149:2 (Canada) Handling and storage of LP cylinders must
conform to LP Gas Code NFPA/ANSI 58 or CSA B149:2 (Canada)
• Do not modify this appliance. Modifications will result in a
safety hazard. Questions regarding certification in other areas
may be addressed to 1-435-752-3922.
• Apartment Dwellers: Check with management to learn the
requirements and fire codes for using an LP Gas appliance at
an apartment. If allowed, use outside on the ground floor with
a 10 foot clearance from walls or rails.
• Before opening LP tank valve, check the coupling nut for
tightness. When appliance is not in use, turn off control knob
and LP tank valve on supply cylinder.
• Never use LP tank if visibly rusted, damaged, or out of date.
• If you notice grease or other hot material dripping from
appliance onto valve, hose or regulator, turn off gas supply at
once. Determine the cause, correct, clean and inspect valve,
hose and regulator before continuing. Perform a leak test.
• The regulator may make a humming or whistling noise during
operation. This will not affect the safety or use of appliance.
• Clean and inspect the hose before each use of the appliance.
If there is evidence of abrasion, wear, cuts or leaks, the
hose must be replaced prior to the appliance being put into
operation. See product tag for hose & regulator information.
• Do not block holes in bottom or sides of appliance.
• Never operate appliance with LP tanks out of correct position
specified in Assembly Instructions.
WARNING: HOSE IS A TRIP HAZARD
• Always close LP tank valve and remove coupling nut before
moving LP tank form specified operating position.
• NEVER store a spare LP tank under or near appliance or in
enclosed areas. NEVER fill the cylinder beyond 80% full. An
overfilled spare LP tank is hazardous due to possible gas
released from the safety relief valve. Failure to follow these
instructions exactly could cause a fire resulting in death or
serious injury.
• If you see, smell, or hear escaping gas, immediately get away
from the LP tank/appliance and call your fire department.
• All spare LP tanks must have safety caps installed on the LP
tank outlet.
