Camina & Schmid Lina 4545 s, Руководство по эксплуатации, Страница: 17 / 40

17
Operation
4.2 Installation and handover
SAFETY INSTRUCTION
Only permit a technician to install your fireplace!

The fireplace must be installed by a technician. Refer
to the attached installation instructions for design and
installation.

Ensure that the fireplace is handed over by the operator
or technician in line with national and local regulations, if
necessary, by representatives of the authorisation body
(chimney sweep).
4.3 Start-up
NOTICE
Incorrect initial start-up can lead to damage to the
fireplace!
SAFETY INSTRUCTION
Only permit a technician to start up your fireplace!
SAFETY INSTRUCTION
The requirements governing safe and proper use need to
be fulfilled and guaranteed prior to initial start-up!
SAFETY INSTRUCTION
Gases can be released from the paintwork when the
appliance is heated up for the first time.
Provide adequate ventilation of the location of the fireplace
during this phase! The paintwork on the fireplace gains
its special strength when exposed to temperature during
initial start-up. This can result in temporary odours. Avoid
inhalation.
4.3.1 Initial start-up by the technician
The fireplace is initially started up by the technician. The
fireplace is heated for the first time and all connections and
fireplace components are checked. These checks need to be
documented and handed over to the operator.
To do so, use the start-up report at the end of these
operating instructions.
The technician needs to hand over to the operator all the
technical documents on the appliance and all accessory
parts for the safe operation of the fireplace. Following initial
start-up, the technician has an obligation to instruct the
operator in the correct and safe handling of the fireplace.
More information regarding initial start-up can be
found in the attached installation instructions.
4.3.2 Start-up by the operator
The operator of the fireplace has an obligation to obtain
instruction on the operation of the fireplace, safe and proper
handling and correct and environmentally-friendly heating
from the contractor.
He needs to hand over all the required technical documents
on the fireplace insert and all accessory parts for the safe
operation of the fireplace. He needs to have read and
understood information on safe and correct handling of the
appliance.
5. Operation
DANGER
Hazardous gases!
Risk of fatal injury by exhaust gas escape!
Ensure sufficient air supply and/or discharge of heating
gases!
NOTICE
Damage caused by heat accumulation!
The fireplace is equipped with ventilation grilles for the
cold air inlet and hot air outlet. The grilles ensure safe air
circulation and prevent the accumulation of heat. Damage
can be caused to the fireplace and/or there can be odour
problems if these openings are not open or can be covered.
Never close or cover the ventilation grilles when the
fireplace is in operation!
Do not place any combustible objects close to hot air
outlets.