CAME STYLO, Инструкция по эксплуатации

Страница: 19 / 64

Page
33 - Manual
FA
01
80
6-
EN
- 0
1/
2
0
24 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. - Translated original ins
tructions
The electrical cables must not touch any parts that may overheat during use (such as
the motor and transformer). Before installation, check that the guided part is in good
mechanical condition, and that it opens and closes correctly. The product cannot be
used to automate any guided part that includes a pedestrian gate, unless it can only
be enabled when the pedestrian gate is secured. Make sure that nobody can become
trapped between the guided and fi xed parts, when the guided part is set in motion.
All fi xed controls must be clearly visible after installation, in a position that allows
the guided part to be directly visible, but far away from moving parts. In the case of
a hold-to-run control, this must be installed at a minimum height of 1.5 m from the
ground and must not be accessible to the public. Where operated with a hold-to-run
control, install a STOP button to disconnect the main power supply to the operator, to
block movement of the guided part. If not already present, apply a permanent tag that
describes how to use the manual release mechanism close to it. Make sure that the
operator has been properly adjusted and that the safety and protection devices and
the manual release are working properly.
Before handing over to the fi nal user, check that the system complies with the harmo-
nised standards and the essential requirements of the Machinery Directive (2006/42/
EC). Any residual risks must be indicated clearly with proper signage affi xed in visible
areas, and explained to end users.
Put the machine’s ID plate in a visible place when the installation is complete. If the
power supply cable is damaged, it must be immediately replaced by the manufacturer
or by an authorised technical support service, or in any case, by qualifi ed staff , to pre-
vent any risk. Keep this manual inside the technical folder along with the manuals of
all the other devices used for your automation system.Make sure to hand over to the
end user all the operating manuals of the products that make up the fi nal machinery.
The product, in its original packaging supplied by the manufacturer, must only be
transported in a closed environment (railway carriage, containers, closed vehicles).
If the product malfunctions, stop using it and contact customer services at https://
www.came.com/global/en/contact-us or via the telephone number on the website.
The manufacture date is provided in the production batch printed on the product label.
If necessary, contact us at https://www.came.com/global/en/contact-us.
The general conditions of sale are given in the offi cial Came price lists.