20
Radio Card Slot
Electronic Card
INSTALL AND PROGRAM THE S 2.0™ RADIO CARD
PROGRAMMING
INSTALL AND PROGRAM THE
S 2.0™ RADIO CARD
1
Disconnect all power to the operator.
2
Insert the S 2.0™ radio card into the slot on the electronic card.
3
Connect power.
NOTE:
The electronic card picks up the S 2.0™ radio card when the
operator is powered up.
4
Press the button on the S 2.0™ radio card (the LED will light).
5
Press the button on the remote control (the LED on the radio card will go out
if programming is successful).
6
Activate the display menu by holding the
ENTER
button for one second.
7
Navigate to
USERS > Add User >
Choose
Confirm? (yes)
.
8
From the
Related Func.
menu choose the desired function (
2-7, Open,
B1-B2, 2-3P,
or
Disabled
) and then press the
ENTER
button to make the
selection. The menu will display "Waiting Code".
9
While the "Waiting Code" is displayed, press and hold the remote control
button. The display will flash the code and then exit to the
Add User
menu
indicating programming is complete.
To program additional remote controls follow steps 5 and 6 above only.
Display
ENTER Button
ERASE THE S 2.0™ RADIO CARD MEMORY
1
Press and hold the button on the S 2.0™ radio card until the LED
goes out (approximately 6 seconds). The memory is now erased.
NOTICE: This device complies with Part 15 of the FCC rules and Industry Canada (IC) licence-exempt RSS-210. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
This Class B digital apparatus complies with Canadian ICES-003.
