CV-550 SPK V3 REFERENCE MANUAL
INSTALLATION INSTRUCTIONS
Page 13 of 33
3.1 Enter management menu operation mode
* (Hold on for more than 2 seconds), (Input admin password) #
3.2 Change admin password
00, (New admin password) #, (Repeat new admin password) #
Note: New admin password must be a 6 digit number.
3.3 Set controller to Single-door mode
Factory default setting is in single door mode. To confirm the mode, the user can set it again by following the steps: 03, 1#
3.4 Set door opening time to 2S
The factory default door opening time is 2 seconds. If user is not sure about the time period, set it again following steps:
34, 2 #
3.5 Add User Card
10, read card, read card …repeat the operation till the last user card.
Note: the keypad can read multiple card credentials continuously (Batch loading). When you hear a long “beep- “and the
indicator light turns to green it means the new card was added successfully. After finishing enrolling the last card, press the
* key to exit the add user card status.
3.6 Add User PIN
11(ID) #, (User PIN) #, (ID) #, (User PIN) #, …repeat the operation till the last user PIN.
Note: The user ID range is from 1 to 20,000 and must not be added before. User PIN is a 4~6 digits number and this number
must not be 1234. Controller can add more users continuously, after the last user PIN, press the * key to exit the add User
PIN status.
Note: Admin password is a 6 digits number, 888888 is the factory default admin password. The user must
change the admin password when they use the keypad. A new admin password is required, otherwise the
user cannot continue other operations. After inputting the new admin password, the LED light will flash
green once and then back to red flash status, all of the other operations will be similar.