AT Command specifications
V.250 Configuration commands
&F
Restore factory defaults
Loads the terminal configuration with factory default values.
The factory default values for each parameter command can be found in the
description for each command in this document.
Note this applies to certain V.250 parameters ONLY, to perform a complete factory
reset refer to the ^FACTORY command.
Default:
N/A
Command
values:
N/A
Z
Soft reset and restore saved settings
Loads the terminal configuration to non-volatile memory
Default:
N/A
Command
values:
N/A
&W Save configuration to non-volatile memory
Saves the terminal configuration to non-volatile memory.
The saved configuration values will be restored automatically on power up or if the
Z command is issued.
Default:
N/A
Command
values:
N/A
E Command
Echo
Whilst in command mode, controls the echo of characters received by the terminal
from the host.
Default:
1
Storage:
&W Command
Command values:
E0
Disable echo of incoming characters in command mode.
E1
Enable echo of incoming characters in command mode.
CDM800 Series V.250 Manual
Page 9 of 33
To suit software version 1.52.2
4/4/2008
