+IFC Local RS-232 flow control
This parameter is used to control the operation of local flow control between the terminal
and the local DTE.
.
Default:
0,0
Storage:
&W
Command values:
AT+IFC=
<DCE_by_DTE>,<DTE_by_DCE>†
Where:
<DCE_by_DTE>
Specifies the method to be used by the DTE to control
the flow of received data from the DCE.
<DTE_by_DCE>
Specifies the method to be used by the DCE to control
the flow of transmitted data from the DTE.
The valid numeric variables for the
+IFC
command are as follows:
0
No
Flow
Control
2
Hardware
By default, the modem is set up as
AT+IFC=2,2
to allow hardware flow
control in both directions.
CDM800 Series V.250 Manual
Page 17 of 33
To suit software version 1.52.2
4/4/2008
