CALIFORNIA ACCENT LIGHTING, INC.
2034 E. Lincoln Ave. #431, Anaheim, CA 92806
ph. 800.921.CALI (2254) or 714.535-7900 \ fx. 714.535.7902
[email protected] \ calilighting.com
© CALI. All rights reserved. CALI reserves the right to make changes or withdraw specifications without prior notice.
Installation Instructions
lip
LEDs
™
LLED
8600-RME
16 of 21
Operating ESA Software cont.
7b.
Patch fixture #2 and fixture #3.
Patch fixture #2
(DMX address 4)
Patch fixture #3
(DMX address 7)
8.
To create a custom scene, click on the Editor tab at the top left of the interface. A new,
blank scene named New Scene will appear by default.
9.
Each scene is made up of a series of steps. Create steps using the Steps menu on the upper
right of the interface.
10.
Set the color value of each channel for each step. Under the DMX universe 1 tab, channel
1 - 4 controls the RGBW value of fixture #1. Channel 5 - 9 controls the RGBW value of
fixture #2. Channel 10 - 12 controls the RGBW value of fixture #3. Use the slider to set
each light level or enter light level in the light level display. Use the arrows at the top and
bottom of slider track to fine tune the value.
Example:
Channel 1 controls fixture #1 red value (65). Channel 6 controls fixture #2
green value (65). Channel 11 controls fixture #3 blue value (65).
11.
After setting RGBW values, set fade time and hold time in the Steps menu in the upper right
of the interface. Double click 00m00s00 under Fade Time, then use the arrow keys to set
desired time in minutes and seconds. Double click 00m00s00 under Hold Time, then use
the arrow keys to set desired time. Double click Dimmer to set brightness value.
Example:
Fade Time - 00m02s00 (2 seconds). Hold Time - 00m04s00 (4 seconds).
Dimmer - 100 (100% brightness).
12.
Create additional steps as desired by repeating steps 9 - 11. Play your scene and make
adjustments to the parameters as desired. When a scene is complete, save as a Show File
(.dlm) as a backup on your computer. Create up to 24 scenes using the Editor tab.
13.
Save scenes to the DMX-RGBW-128C controller by using the Stand Alone tab in the upper
left of the interface. Click the write memory button, then click OK. The program will write
the scenes into the controller to be used independently from the computer.
Note:
Writing the memory will erase all 8 factory-programmed scenes from the controller.
New Scene
Rename Scene
Trigger
Import Scene
Play/Stop
Fade On/Off
Fade Time
Step Number
Hold Time
Dimmer
Copy Step
Record DMX In Levels
Add New Step
Set Levels
Dimming Value
Uncheck if controller will be used
exclusively while connected to PC
Total memory usage.
Create up to 2556 steps across 24 scenes.
Channel 1 (Red)
Light Level Display
Increase Level +1
Decrease Level -1
Slider
Channel 3 (Blue)
Channel 5 (Red)
Channel 6 (Green)
Channel 7 (Blue)
Channel 8 (White)
Channel 9 (Red)
Channel 10 (Green)
Channel 11 (Blue)
Channel 12 (White)
Channel 2 (Green)
Channel 4 (White)
