#9 Viper_SC_Manual_
001-5008-000_Rev12e.docx |
Page 28
―
IP Forwarding Mode.
Display
Bridge/Router.
Default =
Bridge.
IP forwarding mode is configured in
Section 4.3.1
―
Station Relay Point.
Display
Yes/No
. Default =
No.
The Station Relay Point is configured in
Section 4.3.1.
―
Multi-Speed Mode.
Display
Enabled/Disabled.
Default =
Disabled.
Refer to Section 4.3.1
for multispeed configuration.
―
Mode.
Indicate the mode of operation (ANSI, ANSI 900, ETSI)
―
On-line diagnostics Interval.
Displays the time interval (in seconds) when the On-line Diagnostics string will be
transmitted. This interval is configured in
Section 4.3.1.2
―
VPN Status.
Displays the status of the VPN (virtual private network).
OK
/
Ready
when operational. If device is not
operational display will read
Not Ready
and a reason will be shown (Ex.
VPN service disabled
).
―
Unit Status.
Displays the status of the Viper SC and reports any errors. If you do not receive the OK indicator (EX. Error:
Power On Self Test FAILURE, Warning: Radio TX Synthesizer lock failure N/A), use the ACKNOWLEGDE UNIT STATUS and
REFRESH buttons to reset the modem. If the problem persists, contact CalAmp Technical Services for additional
information.
―
Refresh.
Click to
Refresh
the parameters on the current page.
―
Acknowledge Unit Status.
Allows the user to acknowledge and clear errors. Errors remain stored, even after cycling
power, to aid in troubleshooting intermittent faults. Click to return web page displays and Status LED function to
normal operation.
4.1.2
DIAGNOSTICS
From the navigation frame, select
Unit Status
Diagnostics
to view diagnostic data for the local device. Each Viper can be
configured to continually monitor and report its operating conditions and local environment.
Figure 19 – Diagnostics Info
―
Date and time.
Displays the time and date. To configure date and time using an SNTP server, refer to
Section 4.4.6
–
Advanced Setup
Time Source. The SNTP server must also be accessible via the user’s LAN or Internet connection.
―
Time Since Reset.
Displays the amount of time since the unit was last reset. Formatted as Days: Hours: Minutes:
Seconds.
Содержание Viper 100
Страница 42: ...9 Viper_SC_Manual_001 5008 000_Rev12e docx Page 35 Figure 23 Setup Basic Channel Table...
Страница 44: ...9 Viper_SC_Manual_001 5008 000_Rev12e docx Page 37...
Страница 103: ......
