CalAmp | LMU-26xx Install Guide
Page 4
MBUD-0199v3.3
3.1 AVAILABLE WIRING HARNESS
The LMU-26XX ships with the 5C908 wiring harness. This harness requires hard wiring of the power,
ground and ignition wire.
The 5C260 is an optional cable with multiple connectors for standard I/O devices, such as buzzer, light
and driver ID sensor. This enables hard wiring of the power, ground and ignition wire except when using
a vPOD or jPOD. Both vPOD and jPOD provide power to the device without the need for hard wiring.
See installation instructions for proper wiring.
The 5C261 is an optional cable with same connectors as the 5C260; however, it is a short harness and
provides power, ground and ignition from the vehicle’s Jbus or OBD port. This
must
be used with either
the vPOD or jPOD to work properly.
Wire Harness
P/N
Description
N
o
J
PO
D
o
r VPOD
JPO
D
o
r VPOD
B
u
zze
r
Swi
tc
h
/LE
D
5C908
Power Harness (No JPOD or VPOD, No Connectors For
Accessories)
X
5C260
Power Harness (No JPOD or VPOD, with/without Buzzer and/or
Switch LED)
X
X*
X
X
5C261
Power Harness (JPOD or VPOD, with/without Buzzer and/or
Switch LED)
X*
X
X
* For Installations using jPOD or vPOD, the 5C261 optional cable is recommended for an easier install.
Figure 3: P/N 5C908
No jPOD/vPOD Accessories
Figure 2: P/N 5C260
No jPOD/vPOD Accessories
Figure 4: P/N 5C261
jPOD or vPOD