44
Initial Settings
fig.play2.eps
Press the
(Record) button to start recording.
Press the
(Stop) button to stop recording.
Press the
(Play) button to hear what you recorded.
If you’re not satisfied with your performance, you can easily re-record it.
fig.undo.eps
After stopping recording but before performing any other operation, press the VS-700C’s
[UNDO]
button; the
waveform that had been displayed will disappear. Re-recording is as simple as that, so you can continue recording
until you’ve captured a performance you’re satisfied with.
You can also Undo by holding down
[Ctrl]
and pressing
[Z]
on your computer keyboard.
Dropouts may occur during playback or recording if you connect/disconnect another USB device (such as a
memory key), or switch a device's power on/off at the same time that the VS-700 is being used.
Data transfer using USB could get congested if you use the VS-700 and a USB-connected hard disk at the same
time. As a result, the data transfer speed for the hard disk could be significantly reduced. As a storage location
for the audio data that you record and play back, you should avoid using a hard disk that is connected via USB.
Dropouts during playback/recording sometimes occur immediately after the system has started up, or after it
has woken from sleep. Wait for a while, then try the playback/recording again.
You’ve successfully installed SONAR.
Your next step is to read the SONAR User’s Guide and master the basic operations!
8. Now Let’s Record!
VS-700_Install_e.book 44 ページ 2008年11月20日 木曜日 午後5時6分
Содержание Sonar V-STUDIO VS-700
Страница 1: ...4 5 0 1 VS 700_Install_e book 1...
Страница 63: ...VS 700_Install_e book 63...
Страница 64: ...5 1 0 0 0 0 2 2 4 5 0 1 VS 700_Install_e book 64...