Cake Makka, Руководство пользователя

Страница: 50 / 62

Replacing the front wheel
Tool: Allen key 6mm, 8mm, 10mm.
1. Place the vehicle on a stand or similar.
2. Loosen the screw clamping the wheel axle. Use Allen key 6mm.
3. Unscrew the front wheel axle and remove the wheel. Use Allen key 8mm
and 10mm.
4. Mount the new wheel. Tighten the wheel axle screw to 50 Nm.
5. Tighten the screw clamping the wheel axle to 17 Nm. Use Allen key 6mm.
Replacing the rear wheel
CAKE recommends an authorized CAKE workshop perform this service task.
Tool: Allen key 6mm, 8mm, wrench 22mm, 24mm, Torx 20, 25, 30.
1. Remove the battery.
2. Remove the control box lid. Unscrew the 4 screws. Use Torx 25.
3. Disconnect the motor sensor cable.
4. Disconnect the motor cables by unscrewing the blue, green, and yellow
cables. Use an 8mm wrench.
5. On the swing arm, unscrew the 2 cable holder screws. Use Torx 25.
6. On the swingarm bridge, unscrew the 2 fender screws. Use Torx 30.
7. Unscrew the 4 fender screws. Use Torx 20. Remove the rear fender.
8. Loosen the wheel axle nut. Use wrench 22mm and 24mm.
9. Unscrew the 2 screws holding the motor bracket. Use Allen key 6mm.
10. Carefully pull out the wheel.
11. Mount the new wheel. Tighten the wheel axle nut to 50Nm. Use wrench
22mm and 24mm.
12. Mount the motor bracket. Tighten the 2 motor bracket screws to 20 Nm.
Use Allen key 6mm.
13. Tighten the wheel axle nut to 50Nm. Use wrench 22mm and 24 mm.
14. Mount the rear fender. Tighten the 4 fender screws to 10Nm. Use Torx 20.
51