Cake Makka, Руководство пользователя

Страница: 48 / 62

Checking the rims for damages
Wanted state: A smooth rim without any dents or cracks on the edge or at
the spokes.
1. Check the rims for any damages.
2. If necessary, order a new wheel from CAKE and mount it, see
Replacing the
front wheel and/or Replacing the rear wheel.
Checking that the wheels are fastened
Tool: Front wheel: Allen key 6mm, 8mm, 10mm.
Rear wheel: wrench 22mm, 24mm.
1. Check that the front wheel is fastened.
2. Check that the rear wheel is fastened.
Checking the front wheel bearings
Wanted state: When rotated, the bearings should slide smoothly.
1. Place the vehicle on a stand or similar.
2. Loosen the screw clamping the wheel axle. Use Allen key 6mm.
3. Unscrew the front wheel axle and remove the wheel. Use Allen key 8mm
and 10mm.
4. On both sides of the wheel, rotate the bearings.
NOTICE If you remove the spacers, note which spacer belongs to which
side. They must not switch sides.
5. If one of the two bearings does not run smoothly, CAKE recommends you
replace both bearings. Contact an authorized CAKE workshop.
6. If the hub is damaged, replace the entire wheel. Order a new wheel from CAKE.
7. Mount the wheel. Tighten the wheel axle screw to 50Nm.
8. Tighten the screw clamping the wheel axle to 17Nm. Use Allen key 6mm.
49