Caen RFID Lepton7 R7100C, Техническое руководство

Страница: 15 / 22

HARDWARE INTERFACE - Lepton 7 - Technical Information Manual 15
UHF Gen 2 RFID Radio Specifications
Parameter Min. Typ. Max. Unit Conditions
Frequency
902 928 MHz See § Tab. 2.1: Lepton7 R7100C Technical
Specifications page 7
865.6 867.6 MHz
Input impedance 50 Ω
Input match -10 dB S11
Rx sensitivity
-85 dBm 10%PER, assuming 20 dB antenna RL @ 30
dBm output
Tab. 3.6: RF Receiver Specifications
Parameter Min. Max. Unit Notes
Tx Power 10 30 dBm
Meets FCC and equivalent regulatory
constraints
Tx Power Error 1 dB
Difference between desired Tx power and
actual Tx power
Return Loss 0 dB
No damage into open RF port at 30 dBm at
any phase angle
Frequency
865.6 867.6 MHz ETSI EN 302 208 v3.3.1
902 928 MHz FCC part 15.247
Tab. 3.7: RF Transmitter Specifications
Device Input and Output Specifications
Parameter Min. Typ. Max. Unit Conditions
nRST
VIL -0.3 0.8 V
VIH 2 3.6 V
Hysteresis voltage 400 mV
Internal pull-up resistor 14 21 25 kΩ
Reset pulse width 25 μs
WKUP
VIL -0.3 0.8 V
VIH 2 3.6 V
Hysteresis voltage 400 mV
Internal pull-down resistor 20 35 50 kΩ
Digital inputs
VIL -0.3 0.8 V
VIH 2 3.6 V
Hysteresis voltage 400 mV
Internal pull-down resistor 20 35 50 kΩ
Digital outputs
VOL 0.0 0.6 V
VOH 2.7 3.6 V
Drive current (sink or source) 8 mA
UART
Default baud rate 115.2 kbaud
Configurable baud rate 9.6 921.6 kbaud
Data bits 8 bits
Parity bit None
Stop bits 1 bits
Tab. 3.8: Digital Interface Specification