Caen RFID Lepton7 R7100C, Техническое руководство

Страница: 13 / 22

HARDWARE INTERFACE - Lepton 7 - Technical Information Manual 13
Pin# Pin Name Pin Type Description
1 RF RF RF antenna port
2 GND Power Ground
3 RFU Digital I/O Reserved for Future Use
4 BSL_SEL Digital Input Boot Strap Loader interface enable signal
5 GND Power Ground
6 TST Digital Input TST pin to be used for FW recovery/upgrade
7 UART1-RX Digital Input R7100C UART Rx (Receive) from host
8 UART1-TX Digital Output R7100C UART Tx (Transmit) to host
9 NRST Digital Input Active low reset. Connect to open drain driver. R7100C must be
able to internally pull down this signal to reset.
10 GND Power Ground
11 VDC_IN Power DC voltage supply (4.75 – 5.25 V)
12 WKUP Digital Input Wakeup from sleep on rising edge
13 UC_ADC Analog Input Analog to digital converter input
14 UART2-TX Digital Output R7100C Debug UART Tx to host
15 UART2-RX Digital Input R7100C Debug UART Rx from host
16 UC_DAC Analog output Digital to analog converter output
17 GPIO1 Digital I/O General purpose I/O
18 GPIO2 Digital I/O General purpose I/O
19 GPIO3 Digital I/O General purpose I/O
20 GPIO4 Digital I/O General purpose I/O
21 STATUS Digital Output R7100C status indication
22 HEALTH Digital Output R7100C health indication
23-32 GND Power Ground pins on the top and bottom edge of the package
Tab. 3.1: Pin Listing and Signal Definitions
Electrical Specifications
Absolute Maximum Ratings
The absolute maximum ratings (see Tab. 3.2: Absolute Maximum Ratings ) define limitations for electrical and
thermal stresses. These limits prevent permanent damage to the Lepton 7 R7100C.
Operation outside maximum ratings may result in permanent damage to the device.
Parameter Min. Max. Unit Conditions
Supply voltage -0.3 5.5 V VDC_IN pin relative to GND
IO voltage -0.3 4.0 V Non-VDC_IN pin voltages relative to GND
RF input power - +30 dBm Incident to pin 1 (RF)
Storage temperature -30 +100 ºC
Humidity - 95 % RH Non-condensing
ESD immunity - 2 kV Human-body model, all I/O pads
Package moisture sensitivity
level 3 - - - Lepton
7
R7100C from open trays must be
baked before going through a standard
solder reflow process (48 hours at 125 ºC
or 24hrs at 150 ºC)
Tab. 3.2: Absolute Maximum Ratings