OPERATING INSTRUCTIONS
5
WARNING
: This heater must be
properly installed before it is used.
WARNING
: Should the heater over
-
heat, an automatic cut out will turn
the heater off and it will not come
back on without being reset. It can
be reset by unplugging the unit and
waiting 5 minutes before plugging
the unit back in.
If you need to continuously reset
the heater, unplug the unit and
contact a licenced electrician. DO
NOT USE THE HEATER UNTIL
THE CAUSE OF THE PROBLEM IS
DETERMINED AND FIXED.
Power On
En marche
Encedido
Over Temp
Surchauffe
Temperatura
Excesiva
Off
Low
High
SETTING THE THERMOSTAT
Figure 5
air in
yellow light
red light
1. Before connecting or disconnecting plug, turn knob fully
counterclockwise (Figure 5).
2.
Heater is equipped with a thermostat. To adjust temperature to your
individual requirements, turn thermostat control knob clockwise all the
way to turn heater on. The yellow power light will illuminate. When room
reaches desired temperature, turn thermostat knob counterclockwise
until you hear click. Leave in this position to maintain room temperature
at this setting. For additional heat, turn clockwise until you hear click
again and heater will turn on. To shut heater off turn thermostat knob
counterclockwise all the way. The yellow power indicator light will turn
off.
NOTE: Heater is equipped with a fan delay to dissipate residual heat from
the element. Heater fan will run for a brief period after heater has reached
room temperature.
